Cable Fittings

TCI254 is an insulated dust-tight strain-relief grip for cable with an outside diameter of 0.52-0.73 inch. Its 3/4-inch NPT fitting provides a secure cable termination; the wire mesh helps relieve pulling and bending stress at the entry.

TCI143 is an insulated dust-tight strain-relief grip for cable with an outside diameter of 0.40-0.54 inch. Its 1/2-inch NPT fitting provides a secure cable termination; the wire mesh helps relieve pulling and bending stress at the entry.

Straight strain-relief cord connector for 1/2 Inch knockouts; gland clamp grips flexible cord jackets to protect conductors from pull and abrasion at enclosure entry.

Strain relief grip for cables with .40 to .54 Inch outer diameter. Provides mechanical support and protects conductors from tension and abrasion at termination points.

IDEAL 85-376 is an unshielded Cat 6 feed-through RJ45 modular plug for terminating twisted-pair cable. The open-end design allows conductor order to be checked before the wires are trimmed and the plug is crimped.

Strain relief grip for cables with .52 to .73 Inch outer diameter. Provides mechanical support and protects conductors from tension and abrasion at termination points.

Caddy ERC CAT32HP 2 inch cable clip for bundling and securing larger Cat5 or low-voltage runs in Caddy systems.

TCI373 is an insulated dust-tight strain-relief grip for cable with an outside diameter of 0.70-0.97 inch. Its 1-inch NPT fitting provides a secure cable termination; the wire mesh helps relieve pulling and bending stress at the entry.

Safety spring rated at 40 Pounds; used as a secondary support device for suspended lighting and equipment installations to prevent accidental drops.

Eaton BDS53SST stainless single-eye bus drop grip, approximately 0.53 Inch cable range, supports flexible cords and relieves strain at drops.