Romex Connectors

Zinc die-cast 3/4 Inch two-screw clamp connector for NM or SE cable, mounts in a 3/4 Inch knockout and handles typical 14–10 AWG NM combinations, supplied with locknut for secure box connection.

Zinc clamp connector for 3/8 Inch trade nonmetallic sheathed cablle ; mounts in 1/2 Inch knockouts and uses dual screws to secure NM cable, supplied with locknut for box connection.

Nonmetallic push-in connector for NM-B cable; snaps into 1/2 Inch knockouts and grips the cable jacket without screws, providing strain relief and abrasion protection at box or enclosure entries.

Steel coupling that transitions EMT to flexible metal conduit; compression or set-screw EMT end with clamp flex end, providing a bonded connection between raceways.

Nonmetallic cable connector for NM cable; snaps into 3/4 Inch knockouts and clamps cable jacket to protect conductors and resist pull-out.

Nonmetallic strain-relief cord connector for 1/2 Inch knockouts; clamp design grips flexible cords or UF cable while protecting jacket from abrasion.

Nonmetallic push-in connector for 3/8 trade NM cable; snaps into 1/2 Inch knockouts and clamps cable jacket without locknut.

Steel 1/2 Inch NM-B cable connector; snap-in or screw-clamp design secures nonmetallic sheathed cable to enclosures through 1/2 Inch knockouts.

Nonmetallic push-in connector for NM-B cable; snaps into standard knockouts and grips the cable jacket without screws for fast tool-free installation.

Nonmetallic cord connector for 3/4 Inch knockouts; clamp body provides strain relief and abrasion protection for flexible cords or UF cable.